#SteebSunday
#SideShotSunday
Owner: πŸ‘‰ @Steeb38 πŸ‘ˆ
19x12.5  275/30 
20x13    285/30
#IputYourRearOnMyFront 😜
Contact him for your custom-built wheels! πŸ‘ 
———————————————————————
πŸ“· by Randy Goco @itsgoco from @lownslowcrew 
———————————————————————
#5one #steeb38 #infinity #g35  #static #slammed #camber #stretch #hellaflush #poke #stance #functionalstance #dailydriven #6speed #brembo #SteebSpecd
#StanceNation #WhipsChocolate
#TeamStretchNPoke
#TeamMatchingCamber
#SoCal #CarsWithoutLimits #CaniBeat

#SteebSunday
#SideShotSunday
Owner: πŸ‘‰ @Steeb38 πŸ‘ˆ
19x12.5 275/30 
20x13 285/30
#IputYourRearOnMyFront 😜
Contact him for your custom-built wheels! πŸ‘
———————————————————————
πŸ“· by Randy Goco @itsgoco from @lownslowcrew
———————————————————————
#5one #steeb38 #infinity #g35 #static #slammed #camber #stretch #hellaflush #poke #stance #functionalstance #dailydriven #6speed #brembo #SteebSpecd
#StanceNation #WhipsChocolate
#TeamStretchNPoke
#TeamMatchingCamber
#SoCal #CarsWithoutLimits #CaniBeat

Top shot: #FrontFitmentFriday + #FrontalFriday brought to you by Randy Goco @itsGoco. 
——————————————————————-
Bottom shot: #FlashBackFriday circa 2010 at #HellaFlush meet in #VeniceBeach, taken by my iPhone 4.
——————————————————————-
So the story with the #bee: 
Back in 2010, I was still on lowering springs which resulted in noticeable wheel gap shown above. 
The springs are soft so during compression, the sidewall would rub against my fiberglass fenders and gets heated which makes the sidewall becomes sticky gooey.
A bee happened to land on it and got stuck there for hours. 
Before I left, I gave a gentle nudge to set her free πŸ˜‡

Top shot: #FrontFitmentFriday + #FrontalFriday brought to you by Randy Goco @itsGoco.
——————————————————————-
Bottom shot: #FlashBackFriday circa 2010 at #HellaFlush meet in #VeniceBeach, taken by my iPhone 4.
——————————————————————-
So the story with the #bee:
Back in 2010, I was still on lowering springs which resulted in noticeable wheel gap shown above.
The springs are soft so during compression, the sidewall would rub against my fiberglass fenders and gets heated which makes the sidewall becomes sticky gooey.
A bee happened to land on it and got stuck there for hours.
Before I left, I gave a gentle nudge to set her free πŸ˜‡

Steeb’s G circa 2010 πŸ™ŒπŸ™
@Steeb38

See on the left, there’s a small tape measure hanging from the exhaust? 
And there’s a AA battery in the middle, almost doesn’t clear the bottom of his car πŸ˜ˆπŸ‘
19x10.5 245/35
19x12    255/35
———————————————————————
#Infiniti #G35 #VQ35DE #6Speed #Brembo #HellaFlush #Static #SuperSlammed #TeamStretchNPoke 
#LowerThanYourCreditScore 😈

Steeb’s G circa 2010 πŸ™ŒπŸ™
@Steeb38

See on the left, there’s a small tape measure hanging from the exhaust?
And there’s a AA battery in the middle, almost doesn’t clear the bottom of his car πŸ˜ˆπŸ‘
19x10.5 245/35
19x12 255/35
———————————————————————
#Infiniti #G35 #VQ35DE #6Speed #Brembo #HellaFlush #Static #SuperSlammed #TeamStretchNPoke
#LowerThanYourCreditScore 😈

Y U No Flat??!!

Y U No Flat??!!

It’s a lot easier to keep the Deuce clean when I have my 4 minions doing the work ;)
Short clip made by deguzzi aka Jeff. (follow him)
Thanks a lot!! =) Full video is here, by Mikey Dang from PVR Motorsport
PS: the center piece of the wing is actually there, but only cool people can see it.Can you? ;) 

It’s a lot easier to keep the Deuce clean when I have my 4 minions doing the work ;)

Short clip made by deguzzi aka Jeff.Β (follow him)

Thanks a lot!! =)

Β Full video is here, by Mikey Dang from PVR Motorsport

PS: the center piece of the wing is actually there, but only cool people can see it.
Can you? ;)Β 

Picture says it allThis is the clearance on my front suspension, on custom coil-over made by Steven Pan. I have gone 5 months and 11K miles since the front suspension was installed. I’m lucky that MR2’s suspension does not gain camber during compression, otherwise this would not have worked.For video footage of the clearance click here
For those who asks “why?”, click here

Picture says it all

This is the clearance on my front suspension, on custom coil-over made by Steven Pan.Β 
I have gone 5 months and 11K miles since the front suspension was installed.Β 
I’m lucky that MR2’s suspension does not gain camber during compression, otherwise this would not have worked.

For video footage of the clearance click here

For those who asks “why?”, click here

jdmasfk:

SSR’ed SW20 Toyota MR2. Looks the goods!

Sergey’s super-slammed Deuce

(via toyotatumblin)

atran-photo:

Wrong Fitment Crew Meet 2012

Car so high it cleared the spikes easy peasy

atran-photo:

Wrong Fitment Crew Meet 2012

Car so high it cleared the spikes easy peasy

itsJDMYo Anniversary 2011Full coverage is here

itsJDMYo Anniversary 2011
Full coverage is here

(Source: zenki-mo)

KINOD anniversary meet

KINOD anniversary meet

(Source: classicjdm)

Richard’s HellaFlush Deuce

Richard’s HellaFlush Deuce

(Source: importsandmodels)

18x10 +5 235/30 Toyo T1R
19x12.5 +5 285/30 Hankook Ventus V12

(Source: that911)

shelikesitxls:

sickmr2-mike.tumblr.com
shelikesitxls.tumblr.com

Mike’s Widebody SW20 rolling in, WFC meet, Santa Monica, Feb 25th 2012

shelikesitxls:

sickmr2-mike.tumblr.com

shelikesitxls.tumblr.com

Mike’s Widebody SW20 rolling in, WFC meet, Santa Monica, Feb 25th 2012

itsgoco:

@trd3sgte’s MR2
Taken by me.

Crystal clear shot ;)

itsgoco:

@trd3sgte’s MR2

Taken by me.

Crystal clear shot ;)

Taken by Daniel Lee

WFC Meet in Santa Monica, Feb 25th 2012